Monday, February 1, 2010

Wism installation on 6509E

Hi all,
today a new Wism module has been inserted and configured on our 6509E.


Here the log at the insertion time:

Feb  1 11:07:33: %C6KERRDETECT-SP-2-SWBUSSTALL: The switching bus is experiencing stall for 3 seconds
Feb 1 11:07:34: %C6KERRDETECT-SP-2-SWBUSSTALL_RECOVERED: The switching bus stall is recovered and data traffic switching continues
00:00:02: BaseBoard Index:242
00:00:02: DaughterBoard Index:208 (Centralized Forwarding Card)
00:00:02: Gemini Rev#: 3

Firmware compiled 20-Feb-07 14:12 by integ Build [100]


00:00:04: %SYS-CFC7-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) c6lc2 Software (c6lc2-SP-M), Version 12.2(18)SXF9, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Wed 16-May-07 22:48 by kellythw
*Nov 30 00:00:02.155: CFC7: Currently running ROMMON from S (Gold) region
Feb 1 11:08:18: %DIAG-SP-6-RUN_MINIMUM: Module 7: Running Minimal Diagnostics...
Feb 1 11:08:22: %DIAG-SP-6-DIAG_OK: Module 7: Passed Online Diagnostics
Feb 1 11:08:24: %OIR-SP-6-INSCARD: Card inserted in slot 7, interfaces are now online
Feb 1 11:08:48: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:08:48: %WiSM-5-STATE: Controller 2 in slot 7 is Oper-Up
Feb 1 11:21:53: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:21:55: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:21:56: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:21:57: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:22:19: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:22:20: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:22:21: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up
Feb 1 11:22:22: %WiSM-5-STATE: Controller 1 in slot 7 is Oper-Up


Well, I feel a little nervous at the moment of insertion, upgrading 6500s is not my daily routine at the moment, so analyzing the console output, we have had a 3-4 seconds switching stall.
I guess the switching stall was only in the bus, and not in the crossbar and inside the modules, so in fact no issues at all. :-)
Then, the new wism booted up and we (me and Mauri Ale) started the configuration tasks.

Well, tomorrow we will install the new WCS server to control our wisms, maybe I'll do some screenshots.

Marco

No comments: